Informațiile despre acest nou produs sunt în curs de actualizare.
Polymaker has chosen to partner up with 3DWash to provide an alkaline powder that is needed to make a solute for the S2.
3DWASH cleaning agent has been specially optimized for the removal of alkali-soluble support material in technical cleaning systems. During development, emphasis was placed on occupational safety. This has been achieved by a special chemical composition that allows optimum results at low pH values: no heavy personal protective equipment is required in the handling of the cleaning agent, and disposal of the used solution requires only dilution with water to meet generally accepted, worldwide disposal standards.
Several factors impact support removal effectiveness and time:
• Agitation/Circulation (varies by tank type and manufacturer)
• Part Geometry and Amount of Support Material
• pH Level.
• Chemical composition of the solvent
Results will vary based on the above factors. Below are recommended guidelines for using 3DWASH.
Suitable support materials:
3DWASH is good to use with all common support materials such as S2 from Polymaker, Stratasys SR-30, SR-35 etc., Arburg armat21.
Note: 3DWASH is not suitable for HIPS or water-soluble support materials (PVA, BVOH etc.) and cannot be used with support materials of other printing processes such as SLA or Polyjet technology!
Water temperatures between 75°C and 85°C (167° F / 185°F) are most effective for dissolving support materials. The dissolution with temperatures below 65 ° C (149°F), however, is almost ineffective, as the chemistry does not work!
Informațile prezentate sunt furnizate de producător, dar pot fi schimbate de acesta fără ca noi să avem posibilitatea să le actualizăm în timp real.
Pentru mai multe caracteristici și informații actualizate, consultați site-ul producătorului.